![LED Flasher - LED Flasher Installation Boxshi13](https://i.servimg.com/u/f37/19/44/44/74/boxshi13.jpg)
This is what the box looks like
![LED Flasher - LED Flasher Installation Specs11](https://i.servimg.com/u/f37/19/44/44/74/specs11.jpg)
Specs on the box
![LED Flasher - LED Flasher Installation Removi11](https://i.servimg.com/u/f37/19/44/44/74/removi11.jpg)
Use plastic credit cards to remove top bat wing
![LED Flasher - LED Flasher Installation Stripp10](https://i.servimg.com/u/f37/19/44/44/74/stripp10.jpg)
I removed windsield, front fairing, right cover, seat, and center cover to run the cables along the frame.
![LED Flasher - LED Flasher Installation Rearca10](https://i.servimg.com/u/f37/19/44/44/74/rearca10.jpg)
The rear cables exit from under the rear spoiler. Use gourmets to protect cable.
![LED Flasher - LED Flasher Installation Rearle10](https://i.servimg.com/u/f37/19/44/44/74/rearle10.jpg)
The
LED lights came with right angled brackets that I used to mount to the underside of the GIVI mount.
![LED Flasher - LED Flasher Installation Rights10](https://i.servimg.com/u/f37/19/44/44/74/rights10.jpg)
I secured the cables to the square frame pieces. Cables that came with the kit was not long enough to run it anywhere else. The blue tape indicates location of cable run. Use wire zip ties.
![LED Flasher - LED Flasher Installation Contro10](https://i.servimg.com/u/f37/19/44/44/74/contro10.jpg)
This is the controller located in the right compartment.
![LED Flasher - LED Flasher Installation Contro11](https://i.servimg.com/u/f37/19/44/44/74/contro11.jpg)
This is the controller cable connections. Leave enough cable lengths so that you can remove the right side storage box to service the anti freeze. Also use silicone sealer to seal the hole made for the cables to exit the right storage box.
![LED Flasher - LED Flasher Installation Fourwa10](https://i.servimg.com/u/f37/19/44/44/74/fourwa10.jpg)
This is the picture of the rear light.
I originally had planned to modify my turn signals to become four way flashers, but I changed my mind for two reasons. 1} I liked the flashing patterns the kit provided, 2)
LED should run longer on battery only than my turn signals. I do not have to be running the engine to operate the flashers.
The three patterns are: single flash wig wag, three quick flashes wig wag, and the four way flashing.
Hope I explained everything ok.
To Meldrew, and John the answer is "I just like to tinker with my toys". Acturlly DennisB also did a write up on something similar.
My front
LED lights are mounted to Dennis's front light bar.